Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Before putting any of the poles tubes together, note the Safety Stop Bar on the top
pole section and the corrosion armor on the bottom post.
installing the pole in the concrete, the safety stop bar is located toward
back of the pole.
See
5.
Install the alignment screws (#31) into the middle pole and top pole, line up
the slots in the pole with the screw and then slide the three pole sections
together as shown in
Figure 3 & Detail 1A
6. Insert carriage bolts (#7) into the square holes in the middle and top poles
and fasten using washers (#18) nuts (#4) and plastic nut caps(#10). See
Figure 3 & Detail 1B
Insert Carriage bolt (#7)
into the square hole.
POST ASSEMBLY
IMPORTANT
THE FOLLOWING STEPS WILL REQUIRE
AT LEAST TWO CAPABLE ADULTS.
Figure 4.
.
.
INSTRUCTIONS
Be sure when
Detail 1A
7
Detail 1B
5
Figure 3
12
31
2
12
18
4
10
31
2
3
12
2
Publicidad
Tabla de contenido
