QFX R-3 Instrucciones De Operación

R-3
ANTENNA
BAND SWITCH
PRECAUTIONS
• For AC operation,check that the unit's operating voltage Is identical with your local
power supply see['specification's')and use the supplied AC power card:do not use
any other type.For the battery operation, operate the unit only on 4.5v DC using
three UM-1 batteries
• The nameplate indication operating voltage,power consumption etc.ls located on
the rear exterior
• Disconnect the AC power cord from the wall outlet when it is not to be used for an
extended period of time
• This unit Is not disconnected from the ac power source[malns) as long as it is
connected to the wall outlet ,even If the unit itself has been turn off .
• When the Internal batteries are not to be used remove them to avoid damage
caused by the battery leakage and corrosion
• Do not leave the unit In a location near near heat sources.or In a place subject
to direct sunlight.excessive dust.Mechanical vibration or shock
• Should any solid object or liquid fall Into the unit,unplug the unit ant remove
the batteries, and have the unit checked by qualified personnel before operating.
OPERATING INSTRUCTIONS
HANDLE
TUNING
POWER/VOLUME
HEADPHONES
SPECIFICATIONS
• Radio Frequency range:
• FM: 88- l 08MHz
• SWl, 3.2-10.2MHz
• SW2: 9.8-22MHz
• AM: 530- l 600KHz
SENSITIVITY
• FM< <22 DB,MW< <80 DB,SW< <30 DB
• S/N:>>40 DB
POWER
• DC:4.5V[l .5V*3)
• AC: 11 0V /220V 60/50Hz
• Headphone Jack: 3.5mm
WARNING
To prevent fire or shock hazard,do not expose
the unit to rain or moisture To avoid electrical
shock,do not open the radio, refer servicing
to qualified personnel only.