2- Plug USB power and line-in pin into Echo Dot, and then close the silicon cover safely.
3- Turn on ECH-1 into Echo Dot mode.
4- Turn on Echo Dot.
Pair ECH-1 with mobile phone (Bluetooth enabled) and Tablets by Bluetooth
1- Keep the speaker and mobile device within 1 meter.
2- Turn on ECH-1 and switch to Bluetooth mode, Bluetooth indicator flashes blue rapidly, the speaker is under
pairing mode.
3- Switch on Bluetooth function of mobile device to start searching, select "ECH-1" from the device list to pair.
4- Bluetooth indicator changes to solid blue after successfully paired.
Note:
1- If pairing is not successful, turn off the speaker and re-pair again.
2- After successful pairing, paired devices will remember each other so there is no need to pair again unless
pairing information is deleted, you may need to select it manually from the device list on your mobile device.
3- Hold Bluetooth button to disconnect from existing paired device, then Bluetooth indicator will flash blue rapidly
to into pairing mode, then you can pair with another device.
Play/ Pause (under Bluetooth mode)
1-
Press "Bluetooth/Pause/Play/" to pause.
2-
Press again to continue to play.
Next and Previous (under Bluetooth mode)
1-
Press next to go to next track.
2-
Press previous to go back to previous track.
Volume control
1-
Hold volume+/- button to increase or decrease volume.
2-
Control the volume by paired device itself.
AUX-in port
1- Switch speaker to AUX in mode.
2- Connect speaker with any AUX enabled devices via the AUX cable (included).
3- Play music through the devices connected.
TOUBLE SHOTTING / Q & A
Q1: I cannot pair the speaker with my device
A1: Turn off the speaker and turn on again to re-pair.
Q2: The sound is low or completely silent.
A2: Make sure the connected device (either Bluetooth or AUX) is fully functioning.
Under AUX mode, make sure the cable is connected properly.
Check the volume of speaker and device is turned on.
Q3: My device cannot find the speaker
3