Guarantee And Support; Guarantee Restrictions - Philips sonicare DiamondClean Manual De Usario

16
English
Remove the end cap from the toothbrush handle. If the end cap
does not release easily from the housing, repeat step
end cap is released Fig.
Holding the handle upside down, press the shaft down on a hard
surface. If the internal components do not easily release from the
housing, repeat step
Fig. .
Remove the rubber battery cover Fig.
Wedge the screwdriver between the battery and the black frame
at the bottom of the internal components. Then pry the
screwdriver away from the battery to break the bottom of the
black frame Fig.
Insert the screwdriver between the bottom of the battery and the
black frame to break the metal tab connecting the battery to the
green printed circuit board. This will release the bottom end of the
battery from the frame Fig.
Grab the battery and pull it away from the internal components to
break the second metal battery tab Fig.
Caution: Be aware of the sharp edges of the battery tabs so as
to avoid injury to your fingers.
Cover the battery contacts with tape to prevent any electrical short
from residual battery charge. The rechargeable battery can now be
recycled and the rest of the product discarded appropriately Fig.
.

Guarantee and support

If you need information or support, please visit
www.philips.com/support or read the separate worldwide guarantee
leaflet.

Guarantee restrictions

The terms of the international guarantee do not cover the following:
- Brush heads.
- Damage caused by use of unauthorised replacement parts.
.
until the internal components are released
.
.
until the
.
.