Klarstein 10005904 Manual Del Usuario página 8

If you need cooler more, add ice block into upper water slot, see following image:
Note: the ice box should be far way from children to avoid eating
2. Insert the plug directly into a standard AC socket-outlet. Be sure plug fits tightly into outlet. Now
the power pilot light will light on.
3. ON/OFF button
Press the button ON/OFF to start the fan
Note: the default fan speed and fan mode is Medium and Normal when press ON/OFF one time.
4. SPEED button
Press the SPEED button to set the desired fan speed (Low/ Medium/ High).
As per the following sequence: MI HI Lo MI. The fan speed selecting can be circulated and the
speed pilot lamp will be on during the fan operating.
5. VANE button
If you want to enlarge blast area in your room, press the vane button, the fan will blast your room in
large scope; the vane light will be illuminated. To stop vane, just press the vane button again, the vane
pilot light will go out. Moving the horizontal louvers either up or down can make further wind direction
enhancements.
5-1.UP DOWN VANE button
Press the „ UP DOWN VANE „ button once or more, set up the outlet starting page or stop swinging
around air supply, at the same time corresponding instructions icon light or go out.
5-2.LEFT RIGHT VANE button
Press the „ LEFT RIGHT VANE „ button once or more, outlet yawing page starting or stopping air supply
bobbing up and down, and the corresponding instructions icon light or go out.
6. TIMER button
Set the time by pressing the timer button to select a desired timing level as follow, the range is between
0.5-7.5 hours. The pilot light corresponding to the selected timing level will be illuminated.
7. MODE button
The default setting is Normal wind, and then you can press the button Mode again to choose your desired
wind mode as per the following sequence:
8