Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FIXTURE PACKING LIST
Description
1) Rear Housing ...................................................................................1
2) Door Assembly .................................................................................1
3) Screws..............................................................................................1
4) Wire Nuts* ........................................................................................3
*Contained in parts packs
Mounting Hardware NOT Included
Silicone Sealant Required - Purchase Separately
REQUIRED TOOLS:
Remove fi xture components and parts pack. Check to
ensure all parts are included. Note: Account for small parts and
destroy packing material, as these may be hazardous to children.
The TWR wall pack is designed to be mounted to a recessed junction box
or directly to the wall for wiring via surface conduit.
NOT FOR MOUNTING INVERTED OR ON CEILING.
DO NOT AIM UP.
Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power
1. Remove the Door Assembly (2) by loosening the two screws (3) on
the side. Unplug orange connector to disconnect LED wires.
2. Prepare the rear housing for mounting by drilling out appropriate
mounting hole knock outs for surface or junction box mounting. (See Fig).
3. Secure the rear housing to wall in appropriate method. Note:
Assure that fi xture is mounted onto a structurally sound surface and use
mounting hardware appropriate for your application.
For Wet Location compliance, fi xture must be properly sealed! For
moisture seal apply silicone caulking between the mounting surface
and rear housing as well as around sides of rear housing.
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off .
4. Ground fi xture using wire nut to connect the (copper or green) house
supply ground wire & the green fi xture ground wire. Note: If house wiring
does not include a ground wire, consult your local electrical code for
approved grounding methods.
For proper connection, place wire nut over wires
and twist clockwise until tight.
INSTALLATION INSTRUCTIONS
Quantity
5. Connect supply wires using wire nut to connect the black fi xture wire
to the black power supply wire and the white fi xture wire to the white
(neutral) supply wire.
TWR1 LED ALO Models have a fi eld adjustable output module. Use a fl at
screwdriver to turn the dial to choose your desired Lumens output.
Field Adjustable Output Settings for TWR1 LED
ALO
SETTING
1
2
3
4
5
6
7
8*
*ALO device shipped set at maximum setting #8
6. Re-install Door assembly & re-connect LED wires with orange
connector. Secure Door assembly by tightening two screws.
Note: make sure no wires are pinched before tightening screws.
7. Turn on electricity at fuse or circuit breaker box and verify success of
installation.
Make sure all wiring access holes are sealed with weatherproof
silicone sealant (not included)!
page 3
2) Door Assembly
SYSTEM
*LUMENS
WATTS (W)
(approx.)
METAL HALIDE
9
1,100
14
1,700
18
2,200
24
3,000
29
3,500
34
4,100
41
5,000
51
6,200
3) Screws
1) Rear Housing
Figure A
REPLACES
70W
70W
100W
150W
150W
150W
175W
250W
Publicidad
Tabla de contenido
