Installation Instructions - Cadet BTF Serie Instrucciones Para La Instalación

STEP 1
Turn the electrical power off at
the circuit breaker or fuse box.
STEP 5: REFER TO THE INSTRUCTIONS BELOW THAT CORRESPOND TO YOUR THERMOSTAT APPLICATION
Model BTF1 – 240/208 Volt Application
GROUND
SCREW
A. Connect a hot supply wire to the red
thermostat wire.
Model BTF1 - 120 Volt Application
GROUND
SCREW
A. Connect the hot supply wire to the red
thermostat wire.
Model BTF2 – 240/208 Volt Application
GROUND
SCREW
A. Connect the black thermostat wires to the
loose heater wires.

InSTallaTIon InSTrucTIonS

BTF WIRING INSTRUCTIONS - PART 1
STEP 2
Remove the junction box cover
at the end of the baseboard
you wish to wire.
GROUND
SCREW
B. Connect the black thermostat wire to one
of the heater wires.
GROUND
SCREW
B. Connect the black thermostat wire to one
of the heater wires.
GROUND
SCREW
B. Connect the hot supply wires to the red
thermostat wires.
PROCEED TO PART 3
GROUND
SUPPLY
GROUND
SCREW
STEP 3
Connect the supply grounding
wire to the green grounding
screw provided.
PART 2
GROUND
SCREW
STEP 4
Disconnect one factory connector
on the side you have open,
leaving two loose heater wires.
GROUND
SCREW
C. Connect the remaining hot supply wire
to the remaining heater wire.
PROCEED TO PART 3
GROUND
SCREW
C. Connect the neutral supply wire to the
remaining heater wire.
PROCEED TO PART 3