Zenith Heath Manual Del Usuario página 3

Channel settIngs
Note: the channel is factory set. most instal-
lations will not require you to change the
two dip switches on your remote control or
receiver.
Note: If purchasing more than one remote
control system, select different operating
channels unless you want one remote control
to operate multiple receivers.
These remote control products communicate by
using channels that can be changed by sliding dip
switches into the ON or OFF position on both the
remote control and receiver unit(s). Note: Switch
settings must match. Other remote controlled
unit(s) may cause interference and the system
may not function properly. Follow the instructions
below for setting a new channel.
WarnIng: shock hazard. unplug receiver from
power source before changing channels.
1. Locate dip switches on both the remote control
and receiver unit(s).
2. Tochangethechannel,slidedipswitchestoON
or OFF as needed. It is recommended to only
change one dip switch at a time and then check
to see if system is functioning properly.
IMPORTANT: Dip switches must be in the
exact same configuration on both the remote
control and receiver unit(s) for this system to
function properly.
Dip Switches - Shown in the
OFF (Down) Position
(Factory Default)
Dip Switches
598-1304-02
ON
1 2
12 V
3
dIP sWItCh lOCatIOns
ON
1 2
12 V
Remote Control with Back Removed
Indoor Plug-In Receiver
Dip
Switches
ON
1 2
Indoor/Outdoor Plug-In Receiver with Back
Jumper Cover Removed
Dip Switches
Dip Switches