Unit Installation; Installation Instruction - Beko BWH 50 EUC Manual De Instrucciones

3. UNIT INSTALLATION

3.1 Installation Instruction

This electrical water heater shall be installed on a solid wall.
①
of the wall cannot bear the load equal to two times of the total weight of the heater filled fully with
water, it is then necessary to install a special support.
Incase of hollow bricks wall, ensure to fill it with cement concrete completely.
②
After selecting a proper location, determine the positons of the two install holes used for
expansion bolts with hook,
corresponding depth by using a chopping bit with the size matching
the expansion bolts attached with the machine, insert the screws,
make the hook upwards, tighten the nuts to fix firmly, and then hang
the electrical water heater on it (see Fig.2).
Install the supply socket in the wall. The supply socket be 220V.
③
It is recommended to placed the socket on the right above the
heater. The height of the socket to the ground shall not be less
than 1.8m (see Fig.3).
manufacturers, agencies or qualified person who is able to do this so as to ensure the safety.
L (Brown)
N (Blue)
④
If the bathroom is too small, the heater can be installed at another place. However, in order to
reduce the pipeline heat losses, the installation position of the heater shall be closed to the
location shall be as near as possible to the heater.
3.2 Pipelines Connection
① The dimension of each pipe part is G1/2" ; The massive pressure of inlet should use Pa as the
unit; The minimum pressure of inlet should use Pa as the unit.
Make two holes in the wall with the
If there is fault on power cable, it should be replaced by the
E (Yellow/Green)
Expansion bolt (with hook)
≥1.8m
Ground
5
If the strength
(Fig.2)
(Fig.3)