Troubleshooting - STEINEL PROFESSIONAL HBS 200 Manual Del Usuario

Setup & Commissioning
Lens Covers
Lens covers can be used to adjust the high
bay sensor's coverage as needed. The covers
are plastic and snap to the front of an HBS 300
or HBS 200.
LC4
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
30ft/ 30ft/
9.1m 9.1m
22ft 22ft
6.7m 6.7m
LC4 reduced range lens
cover for HBS 300
LC1
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
LC1 aisle starter cover for HBS 200
LC5
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
35ft
40ft 50ft
10.7m 12.2m 15.2m
22ft
6.7m
LC5 180° half moon lens
cover for HBS 300
50ft
15.2m
53ft
16.2m
radial
tangential
- 10 -

Troubleshooting

Malfunction Cause
No power at the
breaker has tripped; light switch
sensor
is in OFF position
short circuit
Lights do not
light level setting is in nighttime
switch ON
mode during daytime operation
lamp burned out
power is off
detection zone not correctly adjusted
Lights do not
abundant heat from the fi xture is
switch OFF
within detection zone and keeps
lights on as a result of temperature
change
Lights keep
the fi xture is moving from side to side
switching ON/OFF
Lights switch ON
HVAC vent is causing air fl ow to
without obvious
switch lights on
movement
Warranty
STEINEL America warrants its products against
defects in material or workmanship for a period
of fi ve years. STEINEL will replace or repair the
item provided that it has not been altered or sub-
jected to abuse, accident, improper installation
or improper use. There are no obligations or lia-
bilities on the part of STEINEL for consequential
Remedy
reset breaker, turn light switch
to ON position, check wiring
with voltage tester
check for proper wiring
connections
adjust light level setting
replace lamp
turn power on at circuit breaker
readjust
mount sensor below fi xture
(EM1 extender module)
stabilize the fi xture
redirect air fl ow away from the
sensor
damages arising out of or in connection with
the use or performance of this product or other
indirect damages with respect
to loss of property, revenue, or
profi t, or cost of removal,
installation or reinstallation.
- 11 -