Fan Assembly. Pgs - Craftmade Ellington ANT54AV5WCR Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 12in.
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the 12in. downrod,
please proceed to instructions following the short dotted
line below.]
To remove the hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop pin.
Slide hanging ball off of original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into top of
extended downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
Remove vice from safety cable by loosening the screw
and nut on the vice.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
Loosen yoke set screws and nuts at top of motor and
remove pin and clip from yoke at top of motor. Be sure set
screw in scroll arm support is loosened and that notches in
scroll arm support face upward. Slide downrod through
canopy, decorative downrod collar, scroll arm support
and yoke cover.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper end of
the downrod.
Thread downrod into the motor housing yoke until holes
for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin and
clip that were previously removed. Securely tighten yoke
set screws and nuts. Lower yoke cover to motor housing.
Remove blade arm screws and lock washers from
underside of motor and then remove stabilization plate.
Important: Stabilization plate may be discarded once
removed but save blade arm screws and lock washers for
later use.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
electrical wiring
downrod
canopy
scroll arm
support
pin
blade arm
screws and
lock washers
page 4
stop pin
hanging ball
A
safety cable
decorative
downrod
collar
yoke cover
stabilization plate
set screw hole
B
vice
clip
yoke set screw
motor housing