Fitting The Strap; Turning On The Collar; Switching Off The Collar; Changing Modes - Dogtek NoBark SONIC Guía De Uso

5
beep sound after inserting the battery, immediately remove it from the battery holder by
tapping briefly the case in the palm of your hand.
- Check the polarity before inserting the battery once again. If you still do not hear any beep
sound, check the operation by switching the collar On and Off.
- Put the battery cover back in place taking care to insert first the little pin at the bottom of
the battery cover (See diagram 3).
- Retighten moderately the 2 screws.

fitting the strAp

- glide the strap alongside the case (See diagram 4)
- place the slide buckle on the strap
- attach the quick-snap buckle to the free edge of the strap

turning on the collAr

Briefly place (for less than 1 second) the magnetic key close to the orange mark located on
front of the collar.
1, 2 or 3 short beep sounds are emitted (according to the chosen mode) and indicate that
the collar has been switched on.
In the factory, the collar's mode is positioned on mode 3 (ultrasound + vibration).

switching off the collAr

Briefly place (for less than 1 second) the magnetic key close to the orange mark located on
front of the collar.
1 long beep sound indicates that the collar has been switched off.

chAnging moDes

In the factory, the collar's mode is positioned on mode 3 (ultrasound + vibration).
To change the collar's mode, when turning on the collar you need to keep the magnetic key
in contact with the orange mark.
A series of beep sounds is emitted (from 1 to 3 beeps) indicating the selected mode.
Keep the magnetic key in contact with the orange mark to run through the modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you turn on the collar, your collar will be on to the last mode you previously
selected.
The chart below indicates how your collar operates according to the mode you have selected:
Number of beep sounds heard when
switching modes
1
2
3

ADJusting the bArk Detection sensitivity

Adjusting the bark detection sensitivity is a very important preliminary operation.
Adjusting it correctly ensures detection of the barking but helps avoid unnecessary
detection.
The detection, must therefore be sufficiently sensitive but not overly sensitive. In factory,
barking detection sensitivity is set on the maximum position (maximum sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as
follows:
- Remove the 2 screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop
for the maximum sensitivity. Turn delicately and without forcing with the supplied
screwdriver.
Mode Operation
1 ultrasound only
2 vibration only
3 ultrasound + vibration
6