Turbosaver TS-1200 Manual De Usuario página 34

the fuse need to be replaced, a 13 A ASTA approved BS 1362 fuse must be used.
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if
it is a molded on plug) and an appropriate one fitted. Warning: dispose of a plug that has
been cut from the power supply cord, as such a plug is hazardous if inserted in a live 13 A
socket outlet elsewhere in the house.
Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover
is omitted or lost until a replacement is obtained –make certain that only the correct fuse
cover is used and fitted.
For plugs with a detachable fuse cover the replacement must be the same as the co-
lor insert in the base of the plug, or as directly by the embossed wording on the base
of the plug.
U.K. ONLY – FITTING A PLUG
Important: the wires in this lead are colored in accordance with the following codes Blue,
Neutral, Brown, live. Please read the instructions given below before connecting the cord
to a plug. If in doubt, please consult a qualified electrician.
As the colors of the wires in the mains lead of this appliance may not correspond with
the colored marking identifying the terminals in your plug, proceed as follows:
1.
the wire wich is coloured BLUE must be connected to the terminal which is marked
with the letter "N" or colored BLACK
2.
which is marked with the letter "N" or colored BLACK
3.
which is marked with the letter "L" or colored RED.
N•either core is to be connected to the earth terminal of a three-pin plug. This appliance
requires a 3 fuse ASTA approved to BS 1362.
34