8 FT. FIREWOOD RACK with COVER
Assembly and Use
Instructions for Model:
82434
VER. 5, 7/23/2012
READ FIRST!
RULES FOR SAFE USE
• USE THE FIREWOOD RACK ONLY ON FLAT SURFACES.
• THE FIREWOOD RACK IS RECOMMENDED FOR USE ON
A HARD SURFACE SUCH AS A CONCRETE PATIO OR
GRAVEL.
• CAUTION! IF USED ON AN UNSTABLE SURFACE, THE
FIREWOOD RACK MAY TIP OVER.
• CAUTION! DO NOT DROP OR SLAM WOOD IN THE
FIREWOOD RACK.
• CAUTION! DO NOT MOVE THE FIREWOOD RACK ONCE
WOOD HAS BEEN LOADED.
PARTS LIST
PART
DESCRIPTION
A
SIDE FRAME
B
BOTTOM FRAME
C
CROSS BAR
D
2.9 IN. BOLT
E
LARGE WASHER
F
LARGE HEXNUT
G
COVER
Thank you for your purchase of the 8 Ft. Firewood Rack
with Cover. At Landmann USA, we strive to provide
you with an easy to use, easy to assemble product.
Should you have questions, issues, a defective part or if
you have any questions concerning its use, please
contact us at: customerservice@landmann-usa.com
-OR-
1-800-321-3473 M-F 8-5 Eastern Time
Proof of purchase may be required.
Landmann® Limited
Distributed by Landmann® USA
Cartersville, GA 30120
www.landmann-usa.com
Made in China
© 2012 Landmann USA
ASSEMBLY INSTRUCTIONS
For easiest assembly, follow the assembly steps in this order.
A Phillips screwdriver and an adjustable
wrench are needed for assembly.
Assembly time: 15 minutes
Assemble the side frames [ A ] and
STEP
1
(4) bottom frames [ B ] as shown
inserting a cross bar [ C ] between
each assembly point. Use (2) 2.9
IN. bolts [ D ], large washers [ E ]
and large hexnuts [ F ] at each
assembly point. Tighten bolts
securely.
QUANTITY
2
4
G
3
12
12
TIED
12
COVER
STRAPS
1
Place cover [ G ] on firewood
STEP
2
and rack. Make sure the
cover straps are securely tied
around both the side frame
leg [ A ] and the bottom
frame [ B ].
The door flap has 6 straps.
Tie these straps with the
cover straps to keep the
door flap closed.
A
B
A
C
B
F
E
D
B
A
D