Exercise Computer; Changing The Battery - Sunny 012S Manual Del Usuario

KEY FUNCTIONS:
MODE: Press the MODE button to select a function. (Time,
Rep/Min, Count, Calorie and Scan)
OPERATION PROCEDURES:
AUTO ON/OFF:
1.
If the steps of the machine are put into motion or the MODE key is pressed, the computer will
activate and will remain active during use. If it goes without signal for approximately 4 minutes, the
console will turn off automatically.
RESET
2. :
The computer can be reset by pressing and holding the MODE key for three seconds, removing the
batteries will also reset the computer and return all function settings back to zero.
MODE
3. :
To select the LOCK MODE setting, press the MODE key when the pointer is on the function you
wish to lock. Once locked, only the selected function will be displayed.
FUNCTIONS:
4.
TIME: Counts the total time of an exercise from start to finish.
CALORIES: Counts the number of total calories burned during an exercise from start to finish.
COUNT: Automatically accumulates the count of steps taken during sessions. Meter counts 1 step after
you step once with each foot.
REPS/MIN: Automatically displays the count of steps per minute.
SCAN: Press the MODE button until the indicator arrow points to SCAN. The indicator arrow will
continue to flash indicating that SCAN mode is active. SCAN mode will automatically scan through
each function in sequence.
NOTE:
1.
If you have an inaccurate reading on the monitor, please replace the battery immediately. (See
instructions below)
2.
Please use (1) LR44, 1.5V battery.
3.
The monitor is auto-powered. It turns on when exercise begins, and it turns off when no movement
is made between 4 to 5 minutes.
4.
All functions will automatically stop calculating when 'STOP' appears in the upper left corner of the
display monitor. This occurs when there is no signal for a period of 4 seconds. Once the exercise
begins again, the meter will automatically start recalculating.

EXERCISE COMPUTER

CHANGING THE BATTERY

Remove the plastic cap from the battery.
1.
Remove the battery using the tool provided or your
2.
fingers.
Insert the new battery using the tool provided or
3.
your fingers. Ensure that the positive side of the
battery which is labeled with a + sign is facing
upward once the new battery is in place.
Place the plastic cap over the battery.
4.
Connect the wire onto the meter.
5.
Insert the meter onto Main Frame.
6.
8
Version 1.9