X-LITE X-702 GT Seguridad E Instrucciones página 14

4.3 Position the left cheek pad against the respective inner polystyrene cheek pad and hook
the elastic loop on the rear onto the liner's left rear snap fastener; push down the faste-
ner onto the seat in the neck-ring area of the shell until you hear it click shut (Fig. 6)
4.4 Now fasten the 2 fasteners on the rear side of the cheek pad onto the polystyrene sup-
port until you hear them click shut (Fig. 5).
4.5 Repeat these steps with the padding of the right cheek pad.
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not been
correctly and completely reassembled.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
- Rinse off with cold water and dry at room temperature away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material, in fact it is apt to change or get
partially destroyed to help absorb shocks.
- Use a damp cloth to clean it and let it dry at room temperature away from direct sun-
light.
- Do not modify the helmet's internal polystyrene components in any way.
- Never use tools or equipment of any sort to carry out the steps described above.
• EYEWEAR ADAPTIVE
The new and exclusive Eyewear Adaptive (EA) is designed for the comfort of eyeglass wearers. In
a quick and easy way, EA allows us to obtain a space in the cheek pads for the glasses temples.
The system is reversible, so the cheek pads can be returned to the initial configuration.
To enjoy the comfort of the helmet with glasses:
1. Remove the cheek pads from the helmet (please refer to paragraph "removable inner com-
fort padding", section "removal", 1.1, 1.2 and 1.3).
2. Open the LEFT cheek pad (Figure 10 C), remove the inner padding at the top and remove
the die cut part.
Note: we advise you to keep this part of the removed padding for any subsequent reuse.
3. Reinsert the inner padding correctly and close the cheek pad.
4. Repeat steps 2 and 3 on the RIGHT cheek pad.
5. Replace the cheek pads on the helmet (please refer to paragraph "removable inner com-
fort padding", section "assembly", from 2.4 to 2.9).
To restore the initial conditions:
1. Remove the cheek pads from the helmet (please refer to paragraph "removable inner com-
fort padding", section "removal", 1.1, 1.2 e 1.3).
2. Open the LEFT cheek pad (Figure 10 D) and insert the die cut padding, which had previ-
ously been removed, at the top of it.
3. Reinsert the inner padding correctly and close the cheek pad.
4. Repeat steps 2 and 3 on the RIGHT cheek pad.
5. Replace the cheek pads on the helmet (please refer to paragraph "removable inner com-
fort padding", section "assembly", from 2.4 to 2.9).
VISION PROTECTION SYSTEM (VPS)
The new and exclusive inner Vision Protection System (VPS) is a
screen with scratch-resistant and fog-resistant treatment.
Using it is very simple and practical: Just lower it to activate it or lift it to remove it from the
field of vision. It is useful in all sorts of situations, both on long journeys out of town and short-
er town trips. Moreover, the fastening system allows you to assemble and disassemble the
sun screen without any tools to allow ordinary maintenance and cleaning operations.
14
®
- moulded sun