Trimmer Operation; Extension Cords - Remington ST3010A El Manual Del Propietario

4

trimmer operation

WARNING: Read and under-
stand this owner's manual before
operating trimmer. Make certain
you read and understand all Safety
Warnings on pages 1 and 2 of this
manual. Improper use of this trim-
mer can result in severe injury or
death from fire, electric shock, or
body contact with moving parts.

Extension Cords

Use proper extension cord with this tool.
Use only a polarized (i.e., one blade is
wider than the other), UL listed exten-
sion cord marked for outdoor use. The
cord must be marked with suffix W or
W-A following the cord type designation.
Example: SJTW-A or SJTW.
Use proper sized cord with this tool. Cord
must be heavy enough to carry current
needed. An undersized cord will cause
voltage drop at trimmer. The trimmer will
lose power and overheat. Follow cord size
requirements listed below.
Cord Length AWG Cord Size
25 feet
50 feet
100 feet
150 feet
Inspect cord often. Replace if damaged.
Connecting Extension Cord
WARNING: Fully seat the ex-
tension cord on the power cord of
tool. Failure to do so could lead to
overheating of trimmer. This could
cause a fire that results in personal
injury to you or others.
118336
The trimmer has a built-in extension cord
retainer. This cord hitch prevents accidental
disconnection of the power cord during
use. The cord hitch is molded into the
trimmer shaft.
1. Plug power cord into extension cord
(see Figure 4-1).
2. Create a loop in the extension cord
and insert through the bottom of the
tool housing (see Figure 4-2).
3. Pull the loop tight around the molded
cord hitch (see Figure 4-3).
Note: An optional method of retaining
the extension cord is shown in Figure
4-4. Use this method with larger-gauge
cords that may not fit into the extension
cord retainer.
18 AWG
16 AWG
16 AWG
Figure 4-1: Plugging extension cord into power cord
14 AWG
REMINGTON® ELECTRIC TRIMMER |
Figure 4-2: Inserting extension cord loop through bottom
of handle
Figure 4-3: Pull extension cord loop tight around molded
cord hitch
Figure 4-4: Optional method of retaining extension cord
5