Publicidad
Enlaces rápidos
WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
2. Install rigid 1-1/2 in. discharge pipe, union,
check valve according to code.
4. Connect pump power supply to a
GFCI-protected receptacle.
Toll Free Help Line: 1-800-742-5044
SUBMERSIBLE
SUMP PUMP
MODEL #3SPHLC, 5SPHLC
QUICK START GUIDE.
SEE INSTRUCTION
MANUAL FOR
COMPLETE DETAILS.
1-1/2-in discharge
pipe
Check valve
GFCI outlet
18 in.
1. Place pump in a sump basin that is at least
18 in. wide and 22 in. deep.
3/16-in
Vent hole
3. Drill a 3/16 in. hole in the discharge pipe,
level with the top of pump. Connect remaining
discharge pipe into main discharge line.
Fill with
water
5. Fill the basin with water to check operation.
Install a basin cover and gasket on top of
the basin.
10 in.
Basin cover
SW1404 A
Publicidad
Manuales relacionados para Flint & Walling 3SPHLC
Resumen de contenidos para Flint & Walling 3SPHLC
- Página 1 SUBMERSIBLE SUMP PUMP MODEL #3SPHLC, 5SPHLC QUICK START GUIDE. SEE INSTRUCTION 18 in. MANUAL FOR COMPLETE DETAILS. WARNING: 10 in. 1. Place pump in a sump basin that is at least FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM POWER SOURCE BEFORE HANDLING.
- Página 2 BOMBA DE SUMIDERO SUMERGIBLE MODELO #3SPHLC, 5SPHLC GUÍA DE INICIO RÁPIDO CONSULTE LOS 45,72 cm DETALLES COMPLETOS EN EL MANUAL DE INSTRUCCIONES 25,4 cm ADVERTENCIA: PARA SU PROTECCIÓN, DESCONECTE SIEMPRE 1. Coloque la bomba en un contenedor para agua de LA BOMBA DE LA FUENTE DE SUMINISTRO sumidero de al menos 45.72 cm (18 pulg.) de ancho...