Publicidad
Idiomas disponibles
Idiomas disponibles
2. Application and intended use
The Multistore is suitable for indoor and outdoor installation, can be walked in and is multifunctional. Sumps
for IBCs and drums, dispensing stations and racks for hazardous material, big waste containers, containers
for gritting material, or stacking containers can be stored in a protected way. If hazardous substances are to
be stored, the appropriate collecting sumps must be installed and the statutory regulations are to be com-
plied with.
Please, observe the safety instructions!
3. Technical description
Design
The Multistore
-
is made of weather-resistant, corrosion-proof polyethylene (PE-LLD).
-
is equipped with a lockable roller door to protect it from unauthorized access.
-
is prepared to be fixed to the ground using ground anchors.
-
is prepared cable and pipe bushings.
-
Operating temperature from -20°C to +40°C
4. Design
Information about place of installation
The Multistore can be installed both indoors and outdoors.
-
To ensure a safe fixation of the Multistore, the ground must be even and suitable for the use of split-
-
anchor screw connections.
The storage system must only be installed onto a paved surface.
-
The storage may not be placed in traffic paths and must be protected against damages caused by col-
-
liding vehicles by taking appropriate measures (e.g. collision guards).
If it is installed outdoors, the Multistore is to be protected from wind impacts, precipitation (snow) and
-
direct solar radiation (UV-radiation), e.g. by sufficient roofing. Direct solar radiation or higher tempera-
tures reduce the dimensional stability and strength.
Clear higher snow loads from the roof.
213141_BA_Multistore_002_INT
10 von 28
06/2015
Publicidad
