EASYHOME EE-3186A Manual De Usuario página 10

Ultrasonic Humidifier
7. Plug the power cord into a wall socket (do not use
extension cord) and turn on the unit by turning the
control knob. (See
8. The Power Light will turn on red. In a few seconds
it will switch to green, indicating that enough water
is in the water basin, and mist will start emitting
through the openings at water tank lid.
9. Use the humidity output regulator control knob to adjust the intensity of the
mist output. Turning the knob clockwise will increase the moisture output,
turning the knob counterclockwise will reduce the moisture output. (See
10
) Note: When at maximum level it is normal to hear a faint dripping sound.
10. When the humidifier runs out of water the power light will turn red, and the
mist output will stop. This
is a safety feature to prevent the humidifier from possibly over heating and
damaging the nebulizer. This safety feature uses a water level sensor to stop
the nebulizer once the water level sinks below the required level in the water
basin. Turn the humidifier off and unplug before removing and refilling the
water tank. Please note that the Power Light on the humidifier body will stay
on. The (red) light signal indicates that the humidifier is turned on and needs
to be refilled.
SET THE CORRECT HUMIDITY OUTPUT
Adjust the mist control so that the mist rises up and gets absorbed by the room
air. Do not turn on too high an output as the mist cannot be absorbed by the air
and accumulates on the surface around the humidifier.
If the humidifier is placed near a fan or air conditioning outlet the mist may be
forced down by the foreign air stream. Change the location of the humidifier or
reduce the output of the other room conditioning appliances.
10
888-367-7373
_____
Fig. 10
)
Correct
USER INSTRUCTIONS UCTION
Fig. 10
Incorrect
AFTER SALES SUPPORT
customer-service@wk-usa.com
Fig.