Graham Field Lumex 7108R Instrucciones página 2

SETUP
Refer to picture on previous page.
s CAUTION: DO NOT use excessive force when installing the seat and lid.
1. Remove frame, seat, lid, pail, cover, and splash guard from carton.
2. Attach front support bar to armrest by depressing the locking button and sliding into the
front support bar channel guide until it clicks into place. Repeat for other side. Ensure the
locking buttons protrude fully from the holes.
3. Attach seat to rear support bar. Push down firmly until the seat snaps into place.
WARNING: When installing the seat on the frame, ensure the seat is evenly
spaced between the side frames to ensure proper stability.
4. Attach lid to rear support bar.
5. In the upright position, place splash shield or pail and cover in frame.
Adjusting Commode Height
1. Depress the height adjustment button and slide the lower leg upward or downward until the
height adjustment button clicks into place in the desired hole.
2. Repeat for other 3 legs.
WARNING: Ensure that all four commode legs are adjusted to the same
height, and that all height adjustment buttons protrude fully through adjust-
ment holes before use.
Inserting Back Support
1. Remove back support from carton.
2. Insert back support into channel guides until back support locking buttons click into place
in channel guide holes.
WARNING: Ensure that locking buttons protrude fully through holes before
use.
Use Commode over Toilet
1. Set commode to desired height (described in previous steps).
2. Remove commode pail and lid.
3. Position splash guard in place on pail supports.
4. Remove back support (described in previous steps).
5. Lift toilet bowl seat.
6. Place commode over toilet with splash shield positioned over the center of the toilet bowl.
Commode is now ready for use. Clean seat and splash guard with disinfectant after each
use.
7108R-INS-LAB-RevA10 2