EGAmaster MASTEREX 79731 Manual De Instrucciones página 6

ENGLISH
• Please read this instruction before any use, maintenance and service of explosion-proof
lights.
• The explosion-proof light must be used by a certain professional training person.
• Must use the replacement parts which produced or appointed by the manufacturer for
maintenance. Make sure the maintenance and service are not in a dangerous place and
fulfilled by professional trained person. Using the parts which not manufactured by the
manufacturer will destroy the explosion-proof performance of the explosion-proof lights.
• The explosion-proof lights should comply with the relevant laws and regulations of the
European Union.
WARNING!
• Do not open when an explosive atmosphere is present!
• Do not charge the battery in hazardous location!
• Do not replace battery when anexplosive atmosphere is present!
WARNING!!
Battery Pack:
• Only use the battery pack from the manufacturer.
Battery: 3.2V 2800mAh 8.96Wh (Single cell battery capacity:3.2V 1400 mAh).
• Only use the adaptor from the manufacturer.
Input Voltage: AC100~240V/50-60Hz
Output Current: DC2A Output Voltage: DC5V
• Using other sources parts may lower the intrinsic safety level of the explosion-proof lights.
Make sure charging in non-dangerous environment.
• IEC 60079-0:2011 Explosive atmospheres, Par0:Equipment, General requirements.
• IEC 60079-11:2011 Explosive atmospheres, Par11:Equipment protection by intrinsic safety
"i".
• IEC60079-28:2014 Explosive atmospheres, Par28: protection of equipment and
transmission systems using optical radiation.
6
IMPORTANT REMINDERS
1. STANDARD