Numax SFN64 Manual Del Usuario página 16

MODEL: SST9032
WARNING:
!
The warnings and precautions discussed
above cannot cover all possible
conditions and situations that may occur.
It must be understood by the user that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the user.
UNPACKING
● This tool has been shipped completely
assembled.
Carefully remove the tool and any
●
accessories from the box.
● Inspect the tool carefully to make sure no
breakage or damage occurred during
shipping.
● Do not discard the packing material until you
have carefully inspected and satisfactorily
operated the tool.
●
If any parts are damaged or missing, please
call 1-888-669-5672.
WARNING:
!
If any parts are missing do not operate
this tool until the missing parts are
replaced. Failure to do so could result in
possible serious personal injury.
WARNING:
!
Do not attempt to modify this tool or
create accessories not recommended for
use with this tool. Any such alteration or
modification is misuse and could result
in hazardous condition leading to
possible serious personal injury.
06
.
HTTP://WWW NUMAXTOOLS COM
FEATURES
SPECIFICATIONS
REQUIRES: 4.31 SCFM with 100
fasteners per minute @ 90 psi
AIR INLET: 1/4 inch NPT
MAGAZINE CAPACITY:
100 fasteners, 18 gauge
WEIGHT: 2.46 lbs
MAXIMUM PRESSURE: 100 psi
–
PRESSURE RANGE: 60 psi 100 psi
PIN SIZE RANGE: 1/2 inch to 1-1/4 inch
Compatible with All Generic 18 Gauge Staples.
FEATURES
● 360° ADJUSTABLE EXHAUST
Allows user to direct air away from face.
●
COMFORT-GRIP HANDLE
For increased comfort and control.
ERGONOMICALLY ENGINEERED BODY
●
Rugged and Comfortable debris free, extending
tool life.
●
NON-MARRING SAFETY CONTACT
Eliminates damage to working surface.
.
1-888-669-5672
MODEL: SST9032
OPERATION
ADJUSTING THE EXHAUST
The adjustable exhaust on the cap of the tool allows
users to direct the exhaust according to operator
preference. To adjust the direction, turn the exhaust
cap in the desired direction.
LOADING FASTENERS
⒈ Connect the tool to the air source.
Push down on the latch button(B). Pull back on
⒉
the magazine cover(C).
⒊ Load a clip of fasteners with the crowns
straddling the magazine rail(D).
⒋ Push the magazine cover(C) forward until latch
button pops up.
Latch button(B)
Magazine cover(C)
Magazine rail(D)
.
HTTP://WWW NUMAXTOOLS COM
WARNING:
!
The tool may fire when it is first
connected to the air resource. Always
connect the tool to the air source before
loading fasteners to prevent injury from
unintended cycling. Always make sure
the tool's magazine is empty at the
beginning of each work session, before
connecting to an air source.
WARNING:
!
Use only those fasteners recommended
for use with this tool. Fasteners not
identified for use with this tool by the tool
manufacturer are able to result in a risk of
injury to persons or tool damage when
used in this tool.
WARNING:
!
Keep the tool pointed away from yourself
and others when loading fasteners.
Failure to do so could result in possible
serious personal injury.
WARNING:
!
Never load fasteners with the workpiece
contact or trigger activated. Doing so
could result in possible serious personal
injury.
.
1-888-669-5672
07