Kinetico Water Systems kube14 Manual Del Usuario página 7

5
Measure the Tubing
Ten feet of plastic tubing are provided for
your convenience. Determine the length
of tubing required to connect the elbow
fittings on the back of the Kube to the
two new adapters.
6
Cut the Tubing
Place the tubing on a clean, flat surface
like a cutting board. Do not kink the
tubing. Using a sharp utility knife, make a
perpendicular cut to your measured length
of tubing.
7
Connect the Tubing
Locate the connections on the back of your
Kube. As indicated by the graphic in Step
5, connect the upper fitting with the faucet
picture to the male adapter. Connect
the lower fitting with the supply valve
picture to the female adapter.
8
Check the Tubing
Firmly push the tubing
elbow fittings and the adapters. Push and
pull the tubing toward and away from the
fittings to ensure that the tubing has been
installed properly and is locked in place. To
remove tubing, depress and hold the collet;
pull the tubing out to remove.
Insert Tubing
3 / " into both the
4
Engagement 3/4"
5