Kinetico Water Systems kube14 Manual Del Usuario página 8

6 6
9
Connect the Cartridges
Align the tabs on the cartridge body
with the tab holes on the face of the
Kube. Fully insert the cartridge and then
twist to lock into place.
a key fitting into a lock. Twist clockwise
to lock in place. The raised area on the
end of the cartridge cap should be lined
up with the lock icon
with the second cartridge.
10
Turn Water Back On
Turn the cold water on at the inlet. Do
this slowly and watch closely to ensure
there are no leaks, at the shut off valve
or at the back of the unit. If you see a
leak, turn it off again and double check
connections.
Congratulations!
Your Kube is installed! Before you put this manual away, register your
Kube at www.kubewater.com.
TIP: It will be like
. Do the same
11
Open Your Faucet
Turn on the cold water at your faucet.
12
Put Your Kube to Work
Turn the blue by-pass knob
until the white indicator points
to the filtered water icon
TIP: The knob will not turn
unless both cartridges are
completely installed.
13
Flush Cold Water
Let water continue to run out of faucet
for about five minutes to activate your
filter cartridges. While you wait, double
check all connections again, and make sure
nothing is leaking. After five minutes turn
off your faucet. Wait 10 minutes and then
turn the cold water back on for another 3
minutes. After 3 minutes turn off your faucet.
You are now ready to enjoy the benefits of
your new Kube. TIP: See Kube Life Guide.