Cavex VacuFormer Manual De Instrucciones página 8

Parts
1. Heating element
2. Frame for deep-draw sheet
3. Frame seal
4. Vacuum plate
5. Timer dial
6. Heating / Vacuum switch(*)
7. Height handle
(*) Heating starts when the switch is set to "Heating" (–); the red light comes on.
The vacuum motor starts when the switch is set to "Vacuum" (=); the green light
comes on.
12
Instructions for use
1. Swivel the heating element to the rear and
press the Heating switch (fig. 1).
Preheating takes around 3 minutes.
Preheating is not always necessary but is
always recommended for sheets thinner
than 1 mm.
2. Place the required deep-draw sheet in the
frame (fig. 2) and close it carefully.
Slide the frame all the way up (fig. 3).
Fig. 3
13
Fig. 1
Fig. 2