Control; Remote Control; Onboard Interface - Paradigm soundtrack Manual Del Operador

Step 4
a) If a wall stud is found, drill a pilot hole into the stud at each mark,
then move to Step 5. OR
b) If no stud is found, install wall anchors at each mark following the
instructions for the type of wall anchor you are using. CAUTION:
We strongly recommend contacting a professional contractor
for this type of installation. Every effort has been made to provide
accurate and error-free installation instructions. Paradigm
Electronics Inc. disclaims liability for difficulties that may arise
from the misinterpretation of information contained in these
instructions.
Step 5
Using the screws, attach the first wall bracket
Fig. 5
to the wall. DO NOT completely tighten
screws (Fig. 5).
Step 6
Repeat all steps for the second bracket.
Use a level to make sure the brackets are
completely straight before tightening screws.
IMPORTANT: Attach audio cables BEFORE mounting soundbar
to wall brackets. See Set-Up Guide for how to attach cables.
Step 7
Move soundbar into place directly over brackets and gently push it to the
wall making direct contact with brackets. You will hear a CLICK as each
bracket makes contact with the soundbar. DO NOT release soundbar
from your grasp until you hear those two clicks.

CONTROL

Remote Control

The supplied remote requires one lithium battery (included). The
remote turns the power on and off, switches between inputs and
controls volume.
Press to
silence the
select
Input
Press again
to restore
Press
to turn
system
on & off
Press and
increased
Press and hold
for decreased
volume

Onboard Interface

Press to Press to synch
Press to turn
select soundbar and
system
Input subwoofer
on and off
Battery Installation
Press to
Follow the diagram on
the back of the Remote
system.
for correct insertion.
+ to + and – to -.
sound
IMPORTANT:
If you lose the remote
contact Paradigm at
hold for
1-905-696-2868 to
purchase a new one.
volume
Loss of remote is
not covered under
Paradigm warranty.
Press and
release to
decrease
volume
Press and
release to
increase
volume
6