SYNQ AUDIO RESEARCH SMP 12.22 Manual De Instrucciones página 7

ENGLISH
REAR PANEL
1. POWER SUPPLY CONNECTOR
Connect the included power supply here. Replace this power supply only with exactly the same type number.
Use of a different adaptor may result in fire or electric shock.
2. POWER SWITCH
Used to switch the mixer on/off. We strongly advise to set the master output faders of the mixer and the gain
controls of your amplifier to zero before you switch the mixer on or off
.
3. MAIN L/R OUTPUT.
Used to connect the master output (Main L/R) of the mixer to a power amplifier (or other equipment)
4. USB PORT
The built-in stereo USB audio interface allows you to connect your mixer to a PC for recording or playback.
Virtually any digital recording software can be used.
The PC/Mac will detect your mixer as a sound card, so normally no drivers are needed. This means also you
will be able to use the standard audio interface controls in the MAC or Windows operating system to make all
the settings.
Getting Started with Windows XP
The first time you plug the mixer into a USB port, Windows will install the universal drivers for that port. A
balloon tip will pop up, telling you it has found the USB Audio codec.
When the installation is ready, the message "Your new hardware is installed and ready to use" will appear
SYNQ 9/118
®
OPERATION MANUAL
SMP12.22
ENGLISH
Most of the time, you'll want the output volume from the computer at it's maximum position, but sometimes
the default setting is much lower, what makes the output level too low. The volume can be increased in
several ways. The simplest is to click the loudspeaker icon (figure 3) in the system tray and drag the slider to
the top
If the icon is not there, the volume can be changed by going to Control Panel and opening Sounds and Audio
Devices.
SYNQ 10/118
®
OPERATION MANUAL
SMP12.22