One-Off Connection To Bluetooth Devices; Volume Control; Turning Off - Marmitek BoomBoom 230 Modo De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21

ONE-OFF CONNECTION TO BLUETOOTH DEVICES

The BoomBoom 230 can remember up to 8 paired devices. As a result it is not
necessary to pair again a device every time you connect. If a 9
with the BoomBoom 230, the device which has been paired firstly with the
BoomBoom 230 will be removed from its memory.
1.
Connect the AC Power Adaptor plug to the DC INPUT [5] located on the
rear panel of the BoomBoom 230.
2.
Connect the AC Power Supply Unit into a suitable wall outlet.
3.
Set the ON/OFF switch [4] to the ON position.
4.
The LED status [3] will light up and stay on, indicating that the
BoomBoom 230 is switched on.
5.
Press and hold the CONNECT [3] button for 3 seconds to put the
BoomBoom 230 into connection mode. Release the CONNECT button
once you hear 2 short beeps. The LED status will now blink rapidly.
6.
Turn on a device that supports Bluetooth, such as an iPod, iPhone,
Android or mp3 device and go to: Settings > General > Bluetooth. Click
ON the Bluetooth. BoomBoom 230 will then appear on the device. Click
ON the BoomBoom 230. The device is now connected and paired with the
speaker. If the device prompts for a pair code, enter:"0000"

VOLUME CONTROL

1.
Tap VOLUME+ to increase the volume. When maximum volume has been
reached, a tone indicator will sound.
2.
Tap VOLUME- to decrease the volume. When minimal volume has been
reached, a tone indicator will sound.

TURNING OFF

Set the ON/OFF button to the OFF position in order to turn the BoomBoom
230 off.
To be completely disconnected from the power input, the main plug of the
AC/DC adapter shall be disconnected from the main.
BoomBoom 230
th
device is paired
5

Publicidad

Tabla de contenido
loading

Tabla de contenido