Telstar TCG024520MD Manual De Instrucciones página 27

GAS COOKER
TCG024520MD
Pressure regulator Flexible metal tube
3. Always use a PVC hose to work from -20ªC to 100ªC. Be sure that hose: •does not have joints. •does not go
on the back of the gas range neither close to the hot air exits. •Its less then 125cm long.
4. If possible, install the gas cylinder outside the kitchen, in a place protected and with air flow.
5. Use a 1⁄2 metallice hose to connect to the gas range.
6. Only use a plastic hose when this one does not go on the back of the gas range.
HOSE INSTALLATION
1. Place the metal clamp on the hose end.
2. Connect the hose to the oven inlet and tighten the clamp.
3. Place the other clamp on the oppsite hose end and connect it to the pressure
regulator, Tighten the clamp.
4. Bolt the pressure regulator to the gas cylinder carefully.
5. After the installation, check if there is any gas leak, using soap or liquid detergent
foam.
6. In order to combat chain first blow a hole in the wall.
Put the plastic cap on it and screw the chain end.
Always check for the validity of the pressure regulator. Hose and regulator should be replaced every 5 years
or when it is broken.
27