HealthCare International SystemRoMedic MiniLift200 Manual De Usuario página 10

Using MiniLift200
Place an appropriately sized ThoraxSling behind and below the user's hips,
(see manual for ThoraxSling).
When the user has placed /his/her feet on the footplate, move the lift
forward towards the user. Place the lift as close as possible to the user.
Take care to ensure that the user's shins are resting securely against the leg
support, and then adjust the leg support so that it does not press against
the user's kneecaps (about 2 cm lower), see picture 1.
1
Raise the locking handle on the lift arm (2) and pull the lift arm out as far as
possible towards the user.
2
Select the sling loop that reaches the hook on the lift arm (shortest loop
alternative). Hook the lift loops to the underside of the sling bar (3).
3
Raise the locking handle and draw the lift arm back, so that the lift straps
on the sling are stretched, and then lower the locking handle back into
position (4).
4
Instruct the user to allow himself/herself to be supported behind the back
during raising (5). Raise the lift to the desired height and ensure that the
user is standing with both feet on the footplate and is grasping the sling bar
handles with both hands to avoid being pinched between the sling bar and
lift loops.
Helpful hint:
Use a longer loop alternative for short users and for users that cannot be
5
fully raised.
Use a shorter loop alternative for taller users, and pull the lift arm out to
allow the user to rise to a standing position.
10