Service information read-out
Basic service information can be read out on the display. To get the service information on the
display please press the lifting arm up button for half a second. The information will be shown
for ½ minute or until other buttons are activated.
•
Total cycles done by the actuator
•
Total work done by the actuator (ampere usage times seconds in use)
•
Total number of overloads
•
Days since last service/Days between services
How to reset the safety switch in case the lifting arm get stuck in
the top position
1.
Push down on the lifting arm, and keep pressure until the procedure is done.
2.
Press up on the handcontrol *for 2 seconds*
*The lifting arm will move upwards*
3.
Press down on the handcontrol. *for 2 seconds*
The reset of the safety switch is completed!
Changing the battery
1
Hand control
Raising/lowering the lift arm
Symbol indicate direction of travel.
Motion stops as soon as the button is released.
If the lift arm encounter an obstacle while lowering, the lift will
immediately stop the motion. In order to continue, the lift arm will
need to be raised slightly by using the hand control before further
lowering.
Widening/narrowing the base
Markings on the buttons indicate function.
Motion stops as soon as the buttons are released.
8
2