Black and Decker SteamXpress AS210 Instrucciones Importantes De Seguridad página 4

2. Read garment's label to help you determine fabric
type. Turn the fabric select dial to appropriate
setting (between 4 and 6) for your fabric (E). The
temperature ready light glows until it reaches the
appropriate temperature. It then cycles on and off
during ironing.
Tip: If unsure of a garment's fiber, test a small area
E
(on an inside seam or hem) before ironing.
3. For optimum performance, let the iron stand for 90 seconds before beginning
to iron.
4. When finished ironing, turn the fabric select dial to lowest heat setting, move
the selector to and unplug the iron.
Note: If you need to add water while ironing, unplug the iron and follow above
steps.
Important: Always stand the iron on its heel rest when powered on but not in
use.
DRY IRONING
1. Make sure variable steam selector is set to
water (see eMPTYING THe WATeR TANK).
2. Turn the fabric select dial to the appropriate setting for your fabric. (Read
garment's label to help you determine fabric type.) The temperature ready
light glows until it reaches the appropriate temperature. It then cycles on and
off during ironing.
Tip: If unsure of a garment's fiber, test a small area (on an inside seam or hem)
before ironing.
3. For optimum performance, let the iron stand for 90 seconds before beginning
to iron.
4. When finished ironing, turn the fabric select dial to lowest heat setting, keep
the variable steam selector set to
Note: If you need to add water while ironing, unplug the iron and follow above
steps.
Important: Always stand the iron on its heel rest when powered on but not
in use.
3-WAY AUTOMATIC SHUTOFF
The automatic shutoff feature in your iron works as follows:
• once the iron reaches appropriate temperature,
it will turn off after 30 seconds of inactivity if left
on its soleplate or tipped over on its side. If left
vertically on its heel rest, it will shut off after
30 seconds
8 minutes (F).
• As soon as you pick up the iron, it will start
heating again. Wait for iron to reheat completely
8 minutes
before resuming operation.
F
6
. You may want to empty the
and unplug the iron.
5
SURGE OF STEAM
Horizontal
1. With the water tank filled to the MAX mark, set fabric select dial to the
appropriate temperature setting (between 4 and 6) and let iron stand on
its heel rest about 90 seconds.
2. For best performance, use surge of steam
Vertical
1. Be sure the water tank is filled to the MAX mark. Hang the garment to be
steamed on a clothes hanger. (Curtains or drapes can be steamed once
they are hung.) set the fabric select dial to the appropriate temperature
setting (between 4 and 6) and let iron stand on its heel rest for about 90
seconds.
2. Hold the iron close to, but not touching, the fabric.
3. Pull the fabric tight in your free hand and pump the
button as you move the iron over the fabric (G).
SPRAY
Use to dampen tough wrinkles at any setting.
1. Check that the water tank is filled with water.
2. Press the button.
G
Note: If spray is weak, pump the button a few times.
ANTI DRIP SYSTEM
The anti drip system prevents water spotting at low temperatures.
EMPTYING THE WATER TANK (OPTIONAL)
1. Turn the fabric select dial to Min (0). Unplug the iron
and let it cool.
2. open the water-fill cover.
3. empty the water by holding the iron over a sink with
the tip pointing down and to one side. Water will
empty out of water-fill opening (H).
H
at 5-second intervals.
6
7