Programming Your Remote; Direct Code Entry - GE 34455 Manual De Instrucciones

Programming Your Remote

Your GE universal remote control is designed to
control multiple audio/video devices such as a TV,
DVD, DVR, satellite, cable and audio devices using
only one remote. To use this remote, you will need to
program it to control the devices of your choice. There
are two ways to program the remote - direct code
entry or auto code search.
Direct Code Entry (Recommended)
1. Locate the Remote Code List provided.
2. Manually turn on the device you wish
3. Press and hold the SETUP button
4. Press and release the device button on
5. Enter the fi rst 4-digit code previously
6. Point the remote at the device. Press
Find the DEVICE CATEGORY you wish
to program (for example TV, DVD,
CBL/SAT, DVR/AUX) and then fi nd the
BRAND of that device. Circle all the
codes under that brand. Example: For
a GE TV, locate the TV code section
then circle all of the GE TV codes.
to control.
until the red indicator light stays on
(approximately 2 seconds) and then
release the SETUP button.
the remote (TV, DVD, CBL/SAT, DVR/
AUX). The red indicator will blink once
and then remain on.
found in the code list using the
number buttons on the remote. If the
code entered is a valid code, the red
indicator light will turn off. If the code
entered is not a valid code, the red
indicator light will fl ash and remain on
allowing you to re-enter the code.
Note: If no buttons are pressed for 35
seconds, the remote will exit the SETUP
mode and you will have to start over.
6