Programming Your Remote; Direct Code Entry - GE 24927 Manual De Instrucciones

Programming Your Remote

Your remote is designed to control multiple audio/video
devices. To use, you will need to program the remote for
your devices. There are two different methods you can
use to program the remote, Direct Code Entry or Auto
Code Search.
• The Direct Code Entry method is the recommended
method as it is the simplest and quickest method in
most cases.
• The Auto Code Search method searches through
all the codes in the remote to find a code for
your device.
Note: This remote comes preprogrammed for Samsung TVs.
Press TV for Samsung TVs.
Direct Code Entry (Recommended)
1. Locate the Code List included with
2. Press and hold down the SETUP button
3. Press and release the device button on
your remote. Find the section for the
type of device you wish to control,
(for example tv, cbl, dvr, dvd, sat, amp,
aux1, aux2). Locate the brand of your
device and circle all the remote codes
for the brand.
on the remote until the red light on the
remote control turns on. Release the
SETUP button. The red light will
remain on.
Note: The red light will either be a small light at the top
of the remote or the power ON/OFF button.
the remote for the type of device you
wish to control, (for example tv, cbl, dvr,
dvd, sat, amp, aux1, aux2). The red light
will blink once and remain on.
Note: Any of the device buttons on the remote can
be programmed to control any of your devices. For
example, you can use the CBL device button on
the remote to control a Satellite Receiver, Digital
Converter Box, Streaming Media Player or any
device category in the Code List.
6