Stiga T8561 Manual Del Usuario página 4

1. Slide a Caster Wheel with Lock (#30) into Caster Beam
as shown in FIGURE 1. On the other end of the Caster
Beam attach a Caster Wheel without Lock (#9).
Make sure you have one Caster Wheel with lock and a
Caster Wheel without lock for each Caster Beam.
Repeat this step to attach the Casters to the second
Caster Beam.
Parts Needed:
2 pcs - #8 Caster Beam
2 pcs - #9 Caster without lock
2 pcs - #30 Caster with lock
8
without lock
9
2. Attach Cross Tube (#7) to Caster Beam Assemblies using four Thumb Screws (#28) as shown
in FIGURE 2. Tighten bolts snug but DO NOT over tighten.
Parts Needed:
1 pc - #7 Cross Tube
Hardware Needed:
4 pcs - #28 #10-24 Thumb Screw
Rubber Hammer
9
with lock
7
READ AND FOLLOW ALL ASSEMBLY, OPERATING,
AND SAFETY INSTRUCTIONS CAREFULLY . AT LEAST
TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE
TOGETHER!
8
30
8
30
30
28
4
with lock
9
NOTE:
Make sure the Caster
Stem is completely installed
into Caster Beam as shown.
without
lock
Figure 1
Figure 2