Stiga T8612 Manual Del Usuario página 3

5. Lay out rails #25 and 26, as shown in Figure 3, around edges
of table top.
6. Line up holes in rails with pilot holes in top and secure using
eighteen screws #20. See Figure 3.
7. Lay Corner Caps #22 on table as shown in Figure 4. If Corner
Cap sticks above table top surface of table, flip over so shorter
distance is against edge. Secure to bottom of table with three
screws #21.
8. Rotate U-support #7 until you see the screw hole in
the slot of U-clip #3. Slide U-support #7 side to side
if necessary.
9. Insert screw #19 through slot in U-clip #3 and into
U-support #7. Thread it all the way into U-support
#7 until it touches the back of the tube. There should
be about 3/8 inch of screw #19 left sticking out. Re-
peat for U Leg #2 and U-clip #34.
Figure 3
Figure 4
Figure 5
3
3
34
This end is the
middle of the table