Stiga T8612 Manual Del Usuario página 6

Figure 10
23. Make sure the legs on the first table top half (the half with the name panel #5) are open. With one person on each side of the table, lift and set
table half on its legs. Place table against a wall as shown above to help stabilize table top half while second half is being attached. Be sure there
is enough room to connect second half.
CAUTION:
24. Place a hex bolt #9 and a locknuts #15 on floor next to caster wheels (on both sides of the table half) so they will be handy for the next step.
CAUTION:
25. With a person on both sides of the second table half, slide the second table half against the first table half. Remove locknuts #15 from screws
#14 on second table half where U-support #7 and linkages #4 join. Align holes in name panels #5 (on first table half) with holes in U-
supports (on second table half). Secure second table half to top hole in name panel #5 using hex bolt #14 installed earlier and locknuts just
removed. Secure second table half to bottom hole in name panel #5 with the two hex bolts #9 and locknuts #15 you placed on the floor
earlier. Tighten locknuts snug but do not overtighten. These joints must pivot. At this point go back and tighten hex bolts #9.
Figure 11
CAUTION:
26. Choose a name panel #5 on either side of the table and install
one safety latch #8 into the right-hand hole on that name panel
as shown in Figures 11 & 12. Use one screw #10 one washer
#17 and one hex nut #16. NOTE: Flange on safety latch
must extend over top of name panel as shown in Figure
11. Safety latch must pivot freely.
27. Go to the other side of the table and install the second safety latch
into the right-hand hole on the other name panel #5.
Safety latches must be attached diagonally across
from each other.
(See Figure 12)
BE SURE THE FIRST TABLE HALF YOU ASSEMBLED (WITH NAME PANELS #5
ATTACHED) IS STABLE AND AGAINST A WALL. DO NOT LEAVE TABLE HALF
STANDING UNATTENDED.
UNTIL THE TABLE HALVES ARE CONNECTED THEY WILL NOT STAND ON THEIR
OWN. IT IS RECOMMENDED TO HAVE THREE PEOPLE TO CONNECT TABLE
HALVES. TWO TO STABILIZE TABLE AND ONE TO BOLT TABLE TOGETHER.
INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL SAFETY
LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
NOTE:
6
Figure 12