Preparing For Measurement - CARING MILL BM 31 Manual De Instrucciones

LCD Display Information:
1. Systolic Pressure
2. Risk Classification
Indicator
3. Diastolic Pressure
4. Irregular Heartbeat
Icon
5. Pulse Rate
6. Pulse Icon
7. Memory Space
Number/Average ( )/
Morning Reading ( )
/Evening Reading ( )
8. User Number
9. Deflation Icon
10. Low Battery Icon
11. Time and Date

5. Preparing for Measurement

Inserting/changing batteries:
1. Remove the Battery
Compartment Cover from the
rear of the device.
2. Insert four "AAA" alkaline
batteries (included) according
to the polarity markings inside
the compartment.
NOTE: Do not use
rechargeable batteries.
3. Reattach the Battery Compartment Cover.
AM PM
11
10
9
8
7
6
5
4
4x1.5 V AAA (LR03)
All LCD Display elements will briefly appear and the year value
1
will flash. Set the date and time as described below. Any
saved measurements will be retained.
Operating with an AC Power Adapter:
You can also operate this device with an AC Power Adapter
2
(not included). You MUST remove the batteries before
powering this unit with an AC Adapter. Only use an AC Power
3
Adapter with specifications according to section "Power supply
unit".
1. Insert the round power plug from the AC Power Adapter
into the AC Adapter Jack on the right hand side of the blood
pressure monitor. Plug the AC Power Adapter into a standard
electrical outlet.
2. When finished using the device, unplug the AC Power
Adapter from the electrical outlet and disconnect it from the
blood pressure monitor. When you unplug the AC Power
Adapter, date and time settings will be lost but saved
measurements will remain.
Setting the hour format, date, and time:
If date and time are not set, stored measurements will not have
a valid timestamp associated with them.
NOTE: Press and hold the + or - Buttons to advance values
rapidly.
1. Press and hold the Memory M Button for about three
seconds so the hour format is flashing.
2. The hour format (12h or 24h) flashes on the LCD Display. Set
the hour format with the +/- Buttons and press the M Button
to confirm.
9