General Specifications - C-LOGIC 5200 Manual De Instrucciones

-
-
Alternating current
... *
Direct current
Diode
Continuity
01))
Autoranging mode
AUTO
MAX Maximum value
MIN Mínimum value
0
Auto power off
Low battery
É:!I
%
Percentage (duty cycle)
Hz, kHz Hertz, Kilohertz (frequency)
mV,V Millivolt, Volt (voltage)
µA,mA,A
Micro amp, Milliamp, Amp (curren!)
Nanofarad, Microfarad, Millifarad
nF, µF, mF
( capacitan ce)
O,kO,MO Ohm, Kilohm, Megaohm (resistance)
REL
Relativa value
Non-contact voltage detection
NCV
C)
Data hold
07
3. Specifications
The Meter should be calibrated annually between
º º
18 C-28 C and a relativa humidity less than 75%.

3.1 General Specifications

3.1.1 Manual and auto range
3.1.2 Full range overload protection
3.1.3The maximum voltage allowed between the measuring
end and the earth:CAT IV measurement environment
for 600V DC or AC(RMS),CAT 111 measurement
environment for 1 OOOVDC or AC(RMS).
3.1.4 Maximum working height: 2000m
3.1.4 Maximum working height: 2000m
3.1.5 Display:LCD
3.1.6 Maximum display value:6599
3.1.7 Polarity indication:"-" indicates negativepolarity
3.1.8 Overload indication:"OL" or "-OL"
3.1.9 Sampling frequency: 0.4s (digital display)/ 0.04s
(bar graph).For curren! readings, 1 s (digital display)
/ 0.1s (bar graph)
3.1.1 O Units display: functions and units
3.1.11 Auto power off: 15 minutes
3.1.12 Power supply: 9V 6F22 battery
3.1.13 Low battery indication: LCD displays"É!l"
3.1.14 Temperatura coefficient: less than 0.1 x specified
º
accuracy/ C
3.1.15 Operating temperature:O
3.1.16 Storage temperature:-1 O
3.1.17 Dimensions:175x85x52mm
3.1.18 Weight:approx.420g(including battery)
º º
C -40 C
º º
C -50 C
DB