Connect The Ductwork For Outside Top Exhaust - Samsung ME21K6000AS Instrucciones De Instalación

pinch the cord or lift the oven by pulling cord.
1.
2. Rotate the front of
the oven up against
the cabinet bottom.
3. Insert a self-aligning screw through the top
center cabinet hole. Temporarily secure the oven
by turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep the power
cord tight. Be careful not to pinch the cord,
especially when mounting flush to the
bottom of the cabinet.
Cabinet Front
Cabinet Front
Cabinet Bottom Shelf
Cabinet Bottom Shelf
Microwave Oven Top Microwave Oven Top
4. Attach the microwave oven to the top cabinet.
5. Insert the 2 self-aligning screws through the
cabinet bottom and, if used, through the filler
blocks into the outer top of the unit. (See the
illustration above). Continue to support the unit
until both screws are inserted and engaged at
least two full turns, then fully tighten both screws
until the unit is secure.
ME21K6000AS_AA_DE68-04108C-00_EN.indd 17
Step-by-step installation guide
Lift the microwave, tilt
it forward, and hook
the slots at the back
bottom edge onto the
four lower tabs of the
mounting plate.
Filler Block
Filler Block
Equivalent to
Equivalent
Depth of
to Depth of
Cabinet Recess
Cabinet Recess
Self-Aligning Screw Self-Aligning Screw
6. Install the grease filters. See the Owner's Manual
packed with the microwave for instructions.
NOTE: For models with installed grease filters, you
do not need to install a filter
E. CONNECT THE DUCTWORK
FOR OUTSIDE TOP
EXHAUST
1. Extend the house duct down to connect to the
exhaust adaptor.
2. Seal the exhaust duct joints using duct tape.
17
House Duct
House Duct
5/20/2016 5:06:34 PM