Changing The Oil; Hydraulic Oil - ATIKA ASP 6 L Manual Original

6. Check the oil seal and replace it if it is damaged in any way.
7. Replace the dipstick into the oil reservoir.
When should I change the oil?
The first oil change should be carried out after 50 operating
hours, and then every 500 operating hours.
Two persons are required for this.

Changing the oil:

1. The splitting column must be in run-in state.
2. Now remove the dipstick.
3. Place a container under the log splitter to catch the old oil.
The container should have a capacity of at least 4.4 litres.
4. Screw off the drain plug to allow the oil to flow out.
5. Insert the seal and drain plug again.
6. Pour in the new hydraulic oil (approx. 2.8 litres) using a clean
funnel.
T e c h n i c a l d a t a
T e c h n i c a l d a t a
Model / Type
Year of construction
Splitting force
Log length
Log diameter
Stroke
Feed speed
Return speed
Hydraulic oil (max.)
Hydraulic pressure
Electric motor performance (power consumption)
Power supply
Dimensions
Weight
drain plug
7. Clean the dipstick and the oil seal.
8. Check the oil seal and replace it if it is damaged in any way.
9. Replace the dipstick.
Dispose of the old oil properly (local oil disposal point). The
old oil must not be poured into the ground or drainage
system, or mixed with other waste.


Hydraulic oil

We recommend the following hydraulic oils for the hydraulic
cylinder:
 Shell Tellus T 22
 Aral Vitam Gf 22
 BP Energol HLP 22
Do not use any other types of oil. The use of any other type
of oil will adversely affect the operation of the hydraulic
cylinder.
S t o r a g e
S t o r a g e
Before each storage:
 Retract the splitting cross.
 switch off device
 Close the oil cap.
 Pull out mains plug.
Store machines that are not in use in a dry locked place protected
against frost and outside the reach of children and unauthorized
persons.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
 thoroughly clean the device.
 Check the device for damaged or worn parts.
 lubricate the splitting column regularly or oil it using
environmentally friendly spray oil.
ASP 6 L
see last page
60 kN (6 t) ± 10 %
max. 1030 mm
min. 120 mm – max. 300 mm
 500 mm
approx. 0.04 m/sek.
approx. 0.17 m/sek.
4.4 litres
24 MPa (240 bar)
P 2.8 kW S6 – 40%
1
230 V~ 50 Hz, 16 A time-lag
length 840 x width 510 x height 990 / 1520 mm
approx. 103.5 kg
 Mobil DTE 11
 or equivalent
27