ATIKA ASP 6 L Manual Original página 29

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 67
P
o
s
s
i
b
l
e
p
r
o
b
l
e
m
P
o
s
s
i
b
l
e
p
r
o
b
l
e
m
Before each fault clearance:
 switch off device
 pull out main plug
Problem
Logs are not being split
properly
(insufficient splitting
performance).
Splitting
column
moves
unsteadily or with strong
vibrations.
Splitting column does not
move in.
Motor starts, but splitting
column does not move in.
Motor will not start.
G
u
a
r
a
n
t
e
e
G
u
a
r
a
n
t
e
e
Please observe the enclosed terms of guarantee.
28
s
s
Possible cause
 The log is not positioned correctly.
 The log exceeds the maximum dimensions or
the wood is too hard for the performance of
the machine.
 Splitting blade does not split log.
 Hydraulic pressure too low.
 Release rods bent (hydraulic tappet not quite
pressed in).
 Incorrect connecting lead (longer than 10 m or
too small cable cross-section).
 Air in the circuit.
 Splitting column not sufficiently lubricated or
oiled.
 Hydraulic pump defective.
Motor turns in wrong direction
 No electrical power.
 Connection cable defective.
 Electric motor defective.
Remedy
 Reposition the log correctly.
 Cut
the
log
to
 Sharpen splitting blade, check for burrs or notches.
 Check the oil level and add more oil if necessary.
If the problem cannot be rectified, refer to the
manufacturer or other approved service centre.
 Arrange for manufacturer or authorised company to
adjust the rods.
 Use the correct connecting lead.
 Check the oil level and add more oil if necessary.
 Lubricate splitting column or oil with environmentally
friendly spray oil.
If the problem cannot be rectified, refer to the
manufacturer or other approved service centre.
 To correct the problem, refer to the manufacturer or
other approved service centre.
To correct the problem, refer to the manufacturer or
other approved service centre.
 Check the fuse.
 Replace the connection cable or have it checked by an
electrician.
 To correct the problem, refer to the manufacturer or
other approved service centre.
the
required
dimensions.

Publicidad

Tabla de contenido
loading

Tabla de contenido