Before Proceeding; Installation Steps - Black and Decker Price Pfister Bernini 808 Serie Manual Del Usuario

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
WARNING: This product has been designed for use with the Price Pfister 0X8
series pressure balancing valve. It will not work with any other product. Please review
the 0X8 valve installation instructions before installing this product
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing unit, remove the old unit
and clean the mounting surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Philips head screwdriver • Adjustable wrench
• Cloth
Your installation will require a pipe nipple for the spout installation as well as other
additional tools.
4
F
H
G
M
N
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Gasket & Trim Flange B Washer
D Stem Extension E Handle
G Hex Wrench H Diverter Spout
K Shower Head L Shower Flange
N Internal Connector
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Pipe wrench • Flashlight
K
E
D
J
C
B
A
C Retainer Sleeve
F Set Screw
J Shower Arm
M Spout Flange
ENGLISH
5
30"
Tub & Shower
5 WORK AREA INSPECTION
Verify that the hole sizes and positions in the wall are correct.
6
A
B
L
6 PLASTERGUARD OPTIONS
A. For installation using plasterguard, knock out Center Section (6B) from Plasterguard
(6A). The use of plasterguard is optional for standard installations.
B. For installation without plasterguard, remove Screws (6C), and Plasterguard (6A).
2

INSTALLATION STEPS

1
1 / " Dia.
4
3
4 / " Dia.
4
4" Dia. for Thin
48"
Wall Installation
Tub & Shower
8" Min.
48"
Shower Only
1
1 / " Dia.
4
6A
6B
6A
6C
30"
Shower Only