Asystems RM-4 Instrucciones De Instalación

INSTALL INSTRUCTIONS
INTRODUCTION
Congratulations on your purchase of the RM-4 remote
preset recall. With a single RM-4 you will be able to recall
up to 4 independent presets. In this instruction manual, we
hope to bring you the most comprehensive introduction to
this product possible.
WIRING
The RM-4 can be wired to the "Preset" section on the rear
of the DMA and DMP series of digital matrix amplifiers
and processors.
As shown, there are pins for each of the 4 preset buttons
on the RM-4, as well as a grounding pin. Each of the 4
pins corresponds with a user-selected "Scene" within the
control software.
RM-4 REMOTE PRESET RECALL
Suggested wiring:
SETUP AND OPERATION
To utilize the RM-4, you simply need to assign a preset
to each of the buttons. This is done within the Control
Software of the DMA/DMP series model you're using.
First, enter the "Global Settings" menu and find the GPIO
submenu. Here you will find the "Preset" panel (shown
below). Each of the pins on the rear of the device will
correspond to the Ports listed here. You can then select
which "Scene" (or preset) you wish to assign to that port.
The pre-saved scenes are all listed within the Utility
menu. Scenes can be saved (and recalled) in this
menu. The "No" in the Preset window on the GPIO
page will correspond with the 'Scene' numbers found
here. The Subject in the Preset window will be updated
automatically.
A single preset can be recalled at any one time. The
button selected on the RM-4 will lock down, releasing
any other preset button that may have previously been
selected.
1
English
www.asystems-sys.com