Asystems RM-2VR Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
INTRODUCTION
Congratulations on your purchase of the RM-2VR rotary
level control. With a single RM-2VR you will be able
to control up to 2 channels of the DMA Digital Matrix
Amplifiers or DMP8800 Digital Matrix Processor at a single
time. Up to four RM-2VRs can be utilized at any one time
to control all 8 outputs. In this instruction manual, we hope
to bring you the most comprehensive introduction to this
product possible.
SETUP AND OPERATION
To utilize the RM-2VR you will need to
activate the remote within the DMA or
DMP software. At the bottom of each
channel within the "Control Panel" window
you will be able to find an on/off button for
the Remote level control.
be able to view the remote level in the
virtual rotary control found directly below
this button.
You will also
DMP8800
RM-2VR REMOTE CONTROL
WIRING
The RM-2VR can be wired to the "Remote Level Control"
section on the rear of the Asystems DMA and DMP series
of digital matrix amplifiers and processors.
As shown, there are pins for each of the devices' 8 input
mixes in addition to a +5V power pin and a grounding
pin. Each of the 8 pins corresponds with the output mix
of the device you're using. This being the case, for a
single RM-2VR to control channels 1 and 2, it should be
wired thusly:
Channel 2 Ground is internally
wired to channel 1 ground
Do not connect the RM-2VR grounding
pins to any other external grounds.
DMA Series
1
English
www.asystems-sys.com