Thulos TH-PC450 Manual De Instrucciones página 10

Assembly of the Mincer Machine.
- (Fig. 1) Hold the head and insert it into the inlet. Turn the head on it
direction shown in the figure until you hear a small sound.
- (Fig. 2) Gently move the head to make sure it is installed correctly.
- (Fig. 3) Install the thrust screw in the head, inserting the long end first and then
turning the screw slightly until it fits into the motor housing.
- (Fig. 4) Place the cutting blade on the thrust screw shaft with the edge towards the front,
as indicated in the figure. If the blade is not properly installed, the meat will not grind.
- (Fig. 5) Place the cutting disc you want to use next to the blade, fitting the tabs into the slots.
- (Fig. 6) Support or press the center of the cutting disc with one finger then with the other hand, screw
the adjusting nut until it is tight. Do not overtighten.
- (Fig. 7) Install the feed tray on the head until it is properly seated.
- Install the grinder on a firm surface.
- Keep free the air inlets located at the bottom and sides of the grinder.