Important Safety Instructions For Battery Chargers - Craftsman CMCBL98021 Manual De Instrucciones

SYMBOLS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V ....................... volts
Hz ..................... hertz
min ................... minutes
or DC ........ direct current
..................... Class I Construction
(grounded)
..................... Class II Construction
(double insulated)
................. Read instruction manual before use
..................... Use proper eye protection

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGERS

SAVE THESE INSTRUCTIONS: THIS MANUAL CONTAINS IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY CHARGERS.
• Before using charger, read all instructions and cautionary markings on charger, battery pack, and
product using battery pack.
WARNING:
SHOCK HAZARD. Do not allow any liquid to get inside charger.
CAUTION:
BURN HAZARD. To reduce the risk of injury, charge only designated Craftsman
batteries. Other types of batteries may burst causing personal injury and damage.
CAUTION:
Under certain conditions, with the charger plugged in to the power supply, the
charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not
limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the power supply when there is no battery pack in
the cavity. Unplug charger before attempting to clean.
WARNING:
THE CHARGER SUPPLIED WITH THIS PRODUCT IS INTENDED TO BE
PLUGGED IN SUCH THAT IT IS CORRECTLY ORIENTATED IN A VERTICAL OR FLOOR
MOUNT POSITION.
• DO NOT attempt to charge the battery pack with any chargers other than the ones in this
manual. The charger and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated
rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to
electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord
could result in risk of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety.
The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has
more capacity than 18 gauge. When using more than one extension to make up the total length, be
sure each individual extension contains at least the minimum wire size.
SAVE THESE INSTRUCTIONS.
A ............... amperes
W .............. watts
n o .............. no load speed
.../min or rpm...revolutions or
4
or AC ... alternating current
.............. earthing terminal
............ safety alert symbol
reciprocation per minute
.............. Use proper respiratory protection
.............. Use proper hearing protection
Craftsman
®