Craftsman CMCBL98021 Manual De Instrucciones página 8

ASSEMBLY
NOTE: Ensure the sweeper is switched off and the
battery is removed before attaching or removing
the sweeper tubes. The tube assembly must be
assembled to the housing before use.
• TUBE ASSEMBLY: To attach the inner tube to the
sweeper, line up the tube with the sweeper housing as shown in figure C. Push the tube into the
sweeper housing until the lock button engages the lock hole in the tube. Repeat this process for
the outer tube.
OPERATION
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF THE OPERATION IS DUSTY. USE
OF RUBBER GLOVES AND SUBSTANTIAL FOOTWEAR IS RECOMMENDED WHEN WORKING
OUTDOORS. FOR HOUSEHOLD USE ONLY.
WARNING:
CUT HAZARD.
reason, wait 10 seconds for the fan to stop rotating before disassembly.
• Always switch off and remove the battery when:
• The power supply cord has become damaged or entangled.
• You leave sweeper unattended.
• Checking, adjusting, cleaning or working on sweeper.
Use sweeper only in daylight or good artificial light.
SWITCHING ON AND OFF (FIGURE D)
WARNING:
USE BOTH HANDS TO GRIP THE PRODUCT FIRMLY
WHEN SWITCHING ON.
To switch the sweeper on, slide the on/off switch forward.
To switch the sweeper off, slide the on/off switch back.
CAUTION:
Do not point unit discharge at self or bystanders.
SPEED DIAL (FIGURE E)
MAX POWER / MAX RUNTIME
The max power / max runtime feature (E1) is located on the tool handle.
It allows you to optimize the tools performance and boost the power
as needed.
• To choose max power, rotate dial to setting 6.
• To maximize runtime rotate dial to setting 1.
• For a combination of both, rotate dial to setting from 2 to 5.
SWEEPER OPERATION
CAUTION:
Always wear safety glasses. Wear a filter mask if
the operation is dusty. Use of gloves, long pants and substantial
footwear is recommended. Keep long hair and loose clothing away
from openings and moving parts. THIS SWEEPER IS FOR
HOUSEHOLD USE ONLY.
NOTE: Ensure the sweeper is switched off and the battery is removed
before attaching or removing the sweeper tubes. The sweeper tube must be
assembled to the housing before use. Install battery after assembly just prior
to use.
• Hold the sweeper with one hand as shown in figure F and sweep from
side to side with the nozzle several inches above the hard surface.
Slowly advance keeping the accumulated pile of debris in front of you.
C
When turning the tool off for tube installation or any other
8
D
E
E1
F