Assembly; Included Parts - Senix CSPE6.5-M Manual Del Operador

This product requires assembly. Carefully remove the
product and any accessories from the box. Make sure
that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product. If any parts are damaged or missing, please
call 1-800-261-3981 for assistance.
WARNING:
Do not use this product if any parts on the packing
list are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.

INCLUDED PARTS

Quantity Item
1 Operator's manual
1 Chain protective cover
1 Bar nut wrench
1 Harness
WARNING:
o prevent an accidental start that could cause serious
personal injury, always disconnect the motor spark plug
wire from the spark plug when assembling parts.
WARNING:
Never install, remove, or adjust any attachments while
power head is running. Failure to stop the motor can
cause serious personal injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
USING THE RIGHT OIL
WARNING:
If any part of the pole saw is missing or damaged, do
not connect to power source or operate the pole saw
until the damaged part is repaired or replaced.
8

ASSEMBLY

DO NOT discard box or packing material until all parts
are examined.
NOTE: Chain and Bar Oil is not included. You must fill
the Pole Saw with SAE30 oil BEFORE use.
NOTE: Remove the Chain/Bar/Blade Protective Cover
before use.
INSTALL THE CHAIN BAR AND CHAIN
WARNING:
Disconnect the spark plug wire before performing
maintenance or assembly procedures.
WARNING:
Cutting edges on chain are sharp.
Use protective gloves when handling chain.
WARNING:
ALWAYS maintain proper chain tension. A loose chain
will increase the risk of kickback. A loose chain may
jump out of chain bar groove. This may injure operator
and damage chain. A loose chain will cause chain,
chain bar, and sprocket to wear rapidly. The chain
life of the saw chain mainly depends upon sufficient
lubrication and correct tensioning. Avoid tensioning the
chain if it is hot, as this will cause the chain to become
over tensioned when it cools down.
1. Place the saw body on a firm and level surface.
2. Using the supplied wrench, turn the bar adjustment
locking nut counter-clockwise to loosen it. Remove
the locking nut, step washer, and cover.
Internal Bolt
Cover
Chain Tensioning Pin
Sprocket
WWW.SENIXTOOLS.COM
Locking Nut/
Step Washer
Wrench